1. Switch on the ZCU102 Board at SW1 (red switch).
2. In few seconds the Ubuntu Desktop will boot as shown in the following figure.
{ZUUImage16.jpg} Ubuntu{Ubunto Desktop Welcome Screen .PNG} ZCU102 Ubuntu Welcome Screen
3. As shown in the following figure there are few icons tailor made like web server, Qt cube demo, Hard glMark2, Soft glMark2 etc. to execute the Zynq UltraScale+ MPSoC specific applications.
{Desktop_Icons.jpg}{Icons.PNG} ZCu102 Ubuntu Desktop Icons
4.Right
4. Right click and above icons.
5.Check
5. Check if the
Use the following command in the terminal to assign a static IP to the board.
$ “ifconfig eth4 192.168.1.112 up”
Once the IP address successfully assigned launch the Web server application.
6. Double click on the Webserver icon on the desktop and following window will pop up. This window shows the IP address of the ZCU102, so use this IP address in the web client of you PC/laptop.
{ZUUImage19.jpg} Web client{ZCU102 WebClient Launch Info.PNG} WebClient Launch Info
7.In
7. In Host PC
http://192.168.1.112
{ZUUImage20.jpg} Web server application
7.Launching8 . To launch the OSG car demo, selectSelect the icon“OSG Car Model” and open then the desktopicon. This will havelaunch the Car displayed like below:Demo as shown below.
The OSG Car Graphics is rendered by the GPU.
{ZUuImage21.jpg.jpg}
8.Using mouse hold9. Drag the car and rotate thenCar to any direction by holding the Mouse left button.
You should see the Car will be rotating.
9.Torotating on the window.
10. To minimize this keys: ‘Ctrl+Alt+D’.
10.The
11. The rootfs also mp4 files.
11.Launching
12. To launch the MP4
{ZUUImage22.jpg} Running MP4 Appication
12.13. Running the
If you are running Power demo directly without the above demo steps then please make sure your have completed the step 5 in the above list to make sure IP address is assigned to Ethernet port. All the terminal application used in power demo are based on telnet so it is mandatory to check Ethernet port is up, assigned IP address and functional.
Navigate to C:\ZynqUS_Demos.
Note: Do not use the mouse or keyboard when the following scripts are running
Double Click the 01_open_terminals_ZCU102.ahk file wait until two terminal windows open. This should take a few seconds.
see two Tera TermTeraTerm terminal windows
One terminal window should show the RPU lock step error messages.
The other terminal should show the Linux booting messages, and eventually stop on the Linux login prompt.